Search: in
Serial Storage Architecture
Serial Storage Architecture in Encyclopedia Encyclopedia
  Tutorials     Encyclopedia     Videos     Books     Software     DVDs  
       





Serial Storage Architecture

Serial Storage Architecture (SSA) is a serial transport protocol used to attach disk drives to servers. It was invented by Ian Judd of IBM in 1990. IBM produced a number of successful products based upon this standard before it was overtaken by the more widely adopted Fibre Channel protocol.

SSA was promoted as an open standard by the SSA Industry Association, unlike its predecessor the first generation Serial Disk Subsystem. [1] A number of vendors including IBM, Pathlight Technology and Viacom produced products based on SSA. It was also adopted as an ANSI X3T10.1 standard. SSA devices are logically SCSI devices and conform to all of the SCSI command protocols.

SSA provides data protection for critical applications by helping to ensure that a single cable failure will not prevent access to data. All the components in a typical SSA subsystem are connected by bi-directional cabling. Data sent from the adaptor can travel in either direction around the loop to its destination. SSA detects interruptions in the loop and automatically reconfigures the system to help maintain connection while a link is restored.

Up to 192 hot swappable hard disk drives can be supported per system. Drives can be designated for use by an array in the event of hardware failure. Up to 32 separate RAID arrays can be supported per adaptor, and arrays can be mirrored across servers to provide cost-effective protection for critical applications. Furthermore, arrays can be sited up to 25 metres apart - connected by thin, low-cost copper cables - allowing subsystems to be located in secure, convenient locations, far from the server itself.

With its inherent resiliency and ease of use, SSA is deployed in server/RAID environments, where it is capable of providing for up to 80 Mbyte/s of data throughput, with sustained data rates as high as 60 Mbytes/s in non-RAID mode and 35 Mbytes/s in RAID mode.

Contents


Link characteristics

The copper cables used in SSA configurations are round bundles of two or four twisted pairs, up to 25 metres long and terminated with 9-pin micro-D connectors. Impedances are 75 ohm single-ended, and 150 ohm differential. For longer-distance connections, it is possible to use fiber-optic cables up to 10 km (6 mi) in length. Signals are differential TTL. The transmission capacity is 20 megabytes per second in each direction per channel, with up to two channels per cable. The transport layer protocol is non return to zero, with 8B/10B encoding (10 bits per character). Higher protocol layers were based on the SCSI-3 standard.

See also

Products which used SSA

References

cs:Serial Storage Architecture de:Serial Storage Architecture simple:Serial Storage Architecture






Source: Wikipedia | The above article is available under the GNU FDL. | Edit this article



Search for Serial Storage Architecture in Tutorials
Search for Serial Storage Architecture in Encyclopedia
Search for Serial Storage Architecture in Videos
Search for Serial Storage Architecture in Books
Search for Serial Storage Architecture in Software
Search for Serial Storage Architecture in DVDs
Search for Serial Storage Architecture in Store




Advertisement




Serial Storage Architecture in Encyclopedia
Serial_Storage_Architecture top Serial_Storage_Architecture

Home - Add TutorGig to Your Site - Disclaimer

©2011-2013 TutorGig.info All Rights Reserved. Privacy Statement