Search: in
RX meter
RX meter in Encyclopedia Encyclopedia
  Tutorials     Encyclopedia     Videos     Books     Software     DVDs  
       





RX meter

Block Diagram Of an RX Meter
Block Diagram Of an RX Meter
An RX meter is used to measure the separate resistive and reactive components of reactive parallel Z network.

The two variable frequency oscillators track each other at frequencies 100 kHz apart. The output of a 0.5-250 MHz oscillator, F1is fed in to a bridge. When the impedance network to be measured is connected one arm across the bridge, the equivalent parallel resistance and reactance (capacitive or inductive) unbalances the bridge and the resulting voltage is fed to the mixer. The output of the 0.6-250.1 MHz oscillator F2, tracking 100 kHz above F1,is also fed to the mixer. This results in a 100 kHz difference frequency proportional in level to the bridge unbalance. The difference frequency signal is amplified by a filter amplifier combination and is applied to a null meter. When the bridge resistive and reactive controls are nulled, their respective dials accurately indicate the parallel impedance components of the network under test.






Source: Wikipedia | The above article is available under the GNU FDL. | Edit this article



Search for RX meter in Tutorials
Search for RX meter in Encyclopedia
Search for RX meter in Videos
Search for RX meter in Books
Search for RX meter in Software
Search for RX meter in DVDs
Search for RX meter in Store




Advertisement




RX meter in Encyclopedia
RX_meter top RX_meter

Home - Add TutorGig to Your Site - Disclaimer

©2011-2013 TutorGig.info All Rights Reserved. Privacy Statement