Traditional NOT Gate (Inverter) symbol International Electrotechnical Commission NOT Gate (Inverter) symbol
In digital logic, an inverter or NOT gate is a logic gate which implements logical negation. The truth table is shown on the right.
Image:NMOS NOT.png|NMOS Inverter Image:PMOS NOT.png|PMOS Inverter Image:CMOS Inverter.svg|Static CMOS Inverter Image:DigitalInverter.png|Schematic of a Saturated-Load Digital Inverter
An inverter circuit outputs a voltage representing the opposite logic-level to its input. Inverters can be constructed using a single NMOS transistor or a single PMOS transistor coupled with a resistor. Since this 'resistive-drain' approach uses only a single type of transistor, it can be fabricated at low cost. However, because current flows through the resistor in one of the two states, the resistive-drain configuration is disadvantaged for power consumption and processing speed. Alternatively, inverters can be constructed using two complementary transistors in a CMOS configuration. This configuration greatly reduces power consumption since one of the transistors is always off in both logic states. Processing speed can also be improved due to the relatively low resistance compared to the NMOS-only or PMOS-only type devices. Inverters can also be constructed with bipolar junction transistors (BJT) in either a resistor-transistor logic (RTL) or a transistor-transistor logic (TTL) configuration.
Digital electronics circuits operate at fixed voltage levels corresponding to a logical 0 or 1 (see binary). An inverter circuit serves as the basic logic gate to swap between those two voltage levels. Implementation determines the actual voltage, but common levels include (0, +5V) for TTL circuits.
Digital building block
This schematic diagram shows the arrangement of NOT gates within a standard 4049 CMOS hex inverting buffer. The digital inverter is considered the base building block for all digital electronics. Memory (1 bit register) is built as a latch by feeding the output of two serial inverters together. Multiplexers, decoders, state machines, and other sophisticated digital devices all rely on the basic inverter.
The hex inverter is an integrated circuit that contains six (hexa-) inverters. For example, the 7404 TTL chip which has 14 pins and the 4049 CMOS chip which has 16 pins, 2 of which are used for power/referencing, and 12 of which are used by the inputs and outputs of the six inverters (the 4049 has 2 pins with no connection).
Digital inverter quality is often measured using the Voltage Transfer Curve, which is a plot of input vs. output voltage. From such a graph, device parameters including noise tolerance, gain, and operating logic-levels can be obtained. Voltage Transfer Curve for a 20 m Inverter constructed at North Carolina State University
Ideally, the voltage transfer curve (VTC) appears as an inverted step-function - this would indicate precise switching between on and off - but in real devices, a gradual transition region exists. The VTC indicates that for low input voltage, the circuit outputs high voltage; for high input, the output tapers off towards 0 volts. The slope of this transition region is a measure of quality - steep (close to -Infinity) slopes yield precise switching.
The tolerance to noise can be measured by comparing the minimum input to the maximum output for each region of operation (on / off).
The output voltage, VOH, can be a measure of signal driving strength when cascading many devices together.
ar: ( ) bn: ( ) ca:Porta NOT da:Inverter (digital elektronik) de:Nicht-Gatter es:Puerta NOT eu:EZ ate logikoa fr:Fonction NON hi: ( ) hr:Logi ki sklop NE (NOT) it:Invertitore la:Porta NON lt:Invertorius ms:Get TAK nl:NOT-poort ja:NOT pl:Bramka NOT simple:NOT gate sk:Hradlo NOT sr: fi:NOT ta: tr:DE L kap s zh: